Additional Information; Troubleshooting - Pioneer XW-LF3-T Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Additional Information

Troubleshooting

Incorrect operation is often mistaken for trouble or malfunction. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble
may lie in another component. Inspect the other components and electrical appliances
being used. If the trouble cannot be rectified even after checking the points below, ask your
nearest Pioneer authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity,
pressing the RESET button may restore normal operation.
• General problem
Problem
The power does not turn on.
The battery does not charge.
Battery charge does not last
very long.
Unable to control the unit, or
unit is not functioning
correctly.
Power automatically
switches to standby without
user action.
24
En
Check that the battery has not run out of charge. Connect the AC
adaptor to the unit to charge it.
Check that the supplied AC adaptor and USB cable are connected
correctly. Try disconnecting them once and then reconnecting
them.
Check that the surrounding temperature is not outside of the range
in which charging is possible. The unit should be charged in an
environment between 5 °C (41 °F) and 35 °C (95 °F).
Check that the surrounding temperature is not too low. Battery
operation time will decrease in a low temperature environment.
Check that the battery pack is not at the end of its life. If the time
required to reach a full charge increases substantially, or playing
time falls dramatically even after charging, the battery pack is at
the end of its life. It can be charged approximately 500 times before
required replacement. This number may decrease depending on
how it is used and how it is stored. If you wish to replace the battery
pack with a new one, please contact your nearest Pioneer
authorized service center.
Use a pin or other long, slim object to press the RESET button
(page 13).
If 10 minutes pass with no Bluetooth device connected, and without
the stereo mini-plug cable inserted in the AUX Jack, the unit will
automatically go into standby.
If battery charge falls to low levels during operation using the
battery, the unit will automatically go into standby.
Remedy

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xw-lf3-kXw-lf1-lXw-lf1-kXw-lf1-w

Table of Contents