Table of Contents
Advertisement
default and all the PCs on the local network will share the WAN IP address to access Internet. In
most case the default setting "dynamic IP" should work. But we can change it to static IP or
PPPoE as well if needed.
4. LAN settings
LAN port is intended to connect all local PCs. Usually you need to enable DHCP server to
automatically assign IP address to local PCs, like following:
5. Wireless settings
Settings in this section are used to control how local PCs, tablets or smarts phone connect to
the wireless router using WiFi. The setting is the same as Gateway mode or Bridge mode. At
a minimum, you need to configure the SSID(network name), region, authentication scheme
ActForNet Technologies Copyright 2014
LEGUANG N800 Configuration Guide
P a g e
| 16
Advertisement
Table of Contents
