Bridge Mode Configuration - ActForNet LEGUANG N800 Configuration Manual

In some cases, you may want to set up virtual access point to separate the wireless network.
N800 supports up to 2 virtual access points. Click "Virtual AP", supply the SSID,
authentication scheme and key and then click "add". After you click "Apply", the system will
reboot with newly added virtual access points:
5. Now you should be able to see the wireless network you just configured from your PC or
tablet, smart phones, etc. Click the network and supply the password/key you just
configured to access the network.
3.3

Bridge Mode configuration

1. Switch to bridge mode
Since the default mode is not bridge mode, you need to manually change the operating
mode as following:
After you click "Apply", the system will ask you to confirm whether to reboot the system to
make the change take effect.
LEGUANG N800 Configuration Guide
ActForNet Technologies Copyright 2014 P a g e | 10