Whirlpool WFW97HEDW Use & Care Manual page 16

Front-loading automatic washer
Table of Contents

Advertisement

Available languages

Available languages

Washer Maintenance
CLEANING LOAD & GO
It is recommended that you rinse out the Load & Go
cartridge when changing detergent types or concentrations,
or when the washer will not be used for an extended period.
1. Pull dispenser out until it stops.
2. Lift out the Load & Go
3. Lift cover on cartridge and flush interior thoroughly with
warm water.
4. Allow to air dry or wipe with a clean, soft towel.
IMPORTANT: Cartridge is not dishwasher safe.
NON-USE AND VACATION CARE
Operate your washer only when you are home. If moving,
or not using your washer for a period of time, follow these
steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer to avoid flooding due
to water pressure surges.
3. Clean the dispensers. See "Cleaning the Dispensers."
16
CARTRIDGE
cartridge.
WINTER STORAGE CARE
IMPORTANT:
To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize washer:
1. Shut off both water faucets, disconnect and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in washer drum and
run washer on NORMAL cycle for about 2 minutes to
mix antifreeze and remaining water.
3. Unplug washer or disconnect power.
TRANSPORTING YOUR WASHER
1. Shut off both water faucets. Disconnect and drain water
inlet hoses.
2. If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
3. Disconnect drain hose from drain system and from back
of washer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside washer drum.
6. Bundle power cord with a rubber band or cable tie to
keep it from hanging onto the ground.
IMPORTANT: Call for service to install new transport bolts.
Do not reuse transport bolts. Washer must be transported
in the upright position. To avoid structural damage to
your washer, it must be properly set up for relocation
by a certified technician.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

W10656464bW10656465bWfw97hedu

Table of Contents