Toro SGR-6 22600 Operator's Manual page 11

1
Figure 12
1. Pivot point
3. Move the machine to the front of the stump and set
the parking brake.
4. Move throttle up to the Engage position. The cutting
wheel will begin rotating.
5. Swing the cutting wheel to one side (Figure 12), then
lower it approximately 13 mm to 25 mm (1/2 inch to
1 inch) into the front-top corner of the stump. Swing
the cutting wheel back and forth, lowering the cutting
wheel approximately 13 mm to 25 mm (1/2 inch to 1
inch) before each sweep, until you have removed the
front portion of the stump to ground level (A through
D in Figure 13).
2
G025887
2. Pivot point when the
parking brake is engaged.
6. Raise the cutting wheel, release the parking brake,
and move the machine forward a few inches. Set the
parking brake.
7. Repeat steps 5 and 6 until you have completely
removed the stump (E through H in Figure 13).
8. Move throttle to the Disengage position, push the
handle down enough to raise the cutting wheel off the
ground. Wait for the cutting wheel to stop rotating
then release the parking brake and pull the machine
away from the stump.
Note: Do not let the front of the machine touch the
ground until you are sure the cutting wheel has stopped
turning.
9. Stop the machine; refer to Stopping the Engine (page
10).
11
Figure 13