Advertisement
2.
INSTALLATION AND SETTINGS OF e-BRIDGE ID GATE
Follow the procedure below to set up the e-BRIDGE ID Gate.
Its settings require users to enter their confidential information. Service technicians in the field can only
display the entry screen and must have the users enter their confidential information.
The table below shows the persons related to the settings and what they do for the settings.
User
Equipment manager
Network administrator
Service technician
Note:
Note:
Each procedure shown in this chapter has an instruction to turn the power of the equipment ON
and to shut it down. If each setting is performed consecutively, turning the power ON or shutting
it down is not necessary.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
Entry of card information required for user authentication
Confirmation of the LDAP server settings required for user authentication
•
Hardware installation
•
System settings
•
Helping users enter the card information
2 - 1
INSTALLATION AND SETTINGS OF e-BRIDGE ID GATE
2
KP-2004
Advertisement
