Xytronic T 1976 Instruction Manual

Temperature controlled soldering station

Advertisement

INSTRUCTION MANUAL
FOR
T 1976
TEMPERATURE CONTROLLED
SOLDERING STATION

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T 1976 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Xytronic T 1976

  • Page 1 INSTRUCTION MANUAL T 1976 TEMPERATURE CONTROLLED SOLDERING STATION...
  • Page 2 Plug the soldering station into an AC outlet and turn the Temperature Control to slightly above the 340 degrees position .Depress the power switch on the front panel of the T 1976 to the “ON”position and allow about 2-3minutes for the soldering tip to heat to operating...
  • Page 3 Proceed to tin the end 2-3mm of the soldering tip with good quality rosin-cored electronics grade solder before going on to use the T 1976 for first time.It is well worth spending a few minutes ensuring the tip has been well tinned ,as this will make the soldering process much easier .Once the tip has been tinned ,wipe it briefly across the...

Table of Contents