Troubleshooting - Protocol Galileo 6182-5U Pilot's Handbook Manual

TROUBLESHOOTING

Symptom Possible Cause
1. Communication between controller and
Galileo
aircraft was not synchronized during set up
does not
2. Battery power depleted on aircraft,
respond
controller or both.
Response to
1. Controller battery power nearly depleted. 1. Replace batteries in controller.
control inputs
intermittent
or erratic
1. The aircraft was not on level ground
Galileo
during synchronization.
will not hover
or strafe
2. Trim settings are incorrect.
correctly
Restart function:
In case of flight disorder, restore factory default settings by the following methods:
1. Press the power switch to turn on the transmitter.
2. Press the power switch to turn on the quad-copter.
3. When the quad-copter indicator flashes slowly, push the throttle lever to the highest
position, and then pull it back to the lowest position. The quad-copter indicator will change
from slow flashing to steady mode.
4. Place the quad-copter on a horizontal position, then push both left and right lever on the
transmitter to the lowest right corners for 2-3 seconds. The indicator on the quad-copter will
change from normal light to quick flashing light. After 2-3 seconds the indicator will change
back to the normal light. This means the quad-copter has restarted/reset successfully.
TIPS ON 3D STUNT & TUMBLING OPERATION
Once you are familiar with the basics of quad-copter flight, you can try some advanced maneuvers! At a
height of at least 10 feet, press the STUNT button [on controller's right side] then move the right stick in
whichever direction desired to perform a 360-degree flip in that direction.
Potential Solution
1. To synchronize, turn on controller, then
turn on aircraft and place it on level
ground. Move throttle stick all the way
forward, then all the way back.
2. Charge aircraft and/or replace
batteries in controller.
1. Re-synchronize aircraft and controller.
2. Reset the trim buttons on the controller
and re-trim flight controls.
8