Power Cord Instructions; Before First Use - Waring Vero Barista ES1500 Instruction Manual

PARTS/ASSEMBLy
A. Main housing
B. On/Off switch
C. Control lever
D. Steam/water dispensing lever
E. Steam/water wand
F. On Indicator lamp
G. Boiler temperature control lamp
H. Steam function indicator lamp
I. Boiler temperature thermometer (˚C and ˚F)
J. Espresso spout (single or double)
K. Water tank
L. Ground espresso holder
M. Pod holder
N. Grille
O. Drip tray
P. Filter (not shown)
Q. Tamper
R. Cup warmer
S. Crema enhancer
T. Power cord (not shown)
U. Coupling seat
Q
S
M
I
R
C
H
B
O
L
fig. 1
J
4

POWER CORD INSTRUCTIONS

This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit into a polarized outlet only one way. If the plug
does not fit fully into the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician. Do not attempt to modify
the plug in any way.
This appliance is for 120 volts only and should not be used with
a converter

BEFORE FIRST USE

1. Check that the household voltage is the same as that
indicated on the technical information plate of the
D
appliance.
2. Place the appliance on a flat and stable surface where it
will not be knocked over.
3. Wash the water tank and fill it with cool tap water up to the
line marked "MAX", then place it securely into position.
Make sure that the control lever (C) is in the vertical
standby position.
K
4. Insert the plug into the electrical outlet.
5. Be sure that the control lever (C) and steam/water
E
dispensing lever (D) are in the vertical standby position, and
then switch the machine to the On position using the On/
Off switch (B). The indicator lamp (F) will turn on, indicating
that the machine is on, as well as the boiler temperature
control lamp (G), indicating that the internal boiler is starting
U
to heat up.
N
6. Let the machine warm up for approximately 5 minutes.
When warming up, your appliance may release small puffs
of steam; this is perfectly normal.
NOTE: Let one cup of water pass through the boiler when
the appliance is turned on for the first time or after it has
not been used for a period of time. Place a container
under the espresso spout (J) and pull the control lever
(C) forward. Push the control lever back to stop the water
from dispensing. You will notice that the indicator lamp
will turn off, indicating that the boiler has reached the right
temperature for preparing the beverage.
5