Pairing Your Motorokr T505; Test And Use - Motorola MOTOROKR T505 Instruction Manual

Pairing your MOTOROKR T505

Before you can use your MOTOROKR T505, you must pair (link) it with your Bluetooth device.
Step A – Ensure T505 is in pairing mode
1 Verify any Bluetooth devices previously paired with your T505 are turned off.
2 Power on your T505 by pressing and holding the Power button for approximately three seconds. The main
indicator light flashes and you hear an audible tone sequence to indicate the device is powered on.
After a few moments, the main indicator light will be steadily lit to indicate T505 is in pairing mode.
Step B – Turn on bluetooth feature on your device
To use your MOTOROKR T505, you must turn on the Bluetooth feature in your phone or music device.
Step C – Set your device to look for your T505
Refer to your device's manual for detailed instructions on accessing Bluetooth and placing it in device
discovery mode
Motorola T505 in the list of discovered devices and confirm by following the on-screen prompts.
When your T505 successfully pairs and connects with your phone or music device, the main indicator light
flashes purple and blue.

Test and use

Your MOTOROKR T505 and phone or music device are now paired and connected. Do the following to verify
proper operation:
To verify handsfree calling operation, dial the number you want to call on the phone and confirm. If your phone
and T505 are successfully paired, you will hear ringing on your T505.
To verify streaming audio operation, play music on your portable Bluetooth music device. If your music source
and T505 are successfully paired and connected for streaming music, you hear music on your T505.
After you have successfully set up your MOTOROKR T505, you don't need to repeat these steps.
For daily use, ensure that your T505 is turned ON and your phone and/or music device's Bluetooth feature is ON.
Note: If your T505 remains in an idle state (not connected to a Bluetooth device) for 15 minutes, it stops searching
for the last connected device. When this occurs, you can manually initiate a search (or "page") for the last
connected device by tapping the Call button.
0000 and confirm.
English
9