Radio Shack TRS-80 Model 100 Basic Manual page 77

Press the down arrow key three times. This should place the cursor on the 4 in line
40. The display should appear as:
I:~! E~
l·:j D
(-~i ~i~ ., ,t; (;~<{f
IF
A$~::>N%
THEN GO"f'O
P P I
i\~T
II
l,\(;;iE:
I
~:.~
II
OJ
l~
DATA DAN, 32, RON, 38, LINDA, 42~
DATA BETTY, 35. RALPH. 29, SKIP, 3~
The cursor must now be moved to the right until it is over the last character (the
triangle) in line 40. If the right arrow key is pressed and held down; the cursor will
move to the right until the key is released. Using the right arrow key in this fashion,
move the cursor to the desired position.
If
you go too far, use the back arrow key to
back up to the correct position.
Once the cursor is correctly positioned, you are ready to insert the letter G. This is
done simply by pressing
CID.
Do NOT press (ENTER) after
CID
is pressed. You will
notice that the letter G is displayed in the correct place and the carriage return
character moves one column to the right. At this point, the display should appear as:
INPUT "NAME"; Ns4
j~E:tlD
1", :;;
~
,1\6
IF A$<>NS THEN GOTO 20
.<+~~ PF~INT
"l\(::iE:
I~:)", It:;G~
DATA DAN, 32, RON, 38, LINDA,
42~
DATA BETTY, 35, RALPH, 29, SKIP,
When the Editor is used, the system is always in the "insert" mode. This means that
if a keyboard character is typed, this character will be inserted in the line where the
cursor was placed. Characters to the right of the cursor move over to make room for
the inserted character.
You must remember to use the arrow keys to move about on the display, and not the
space bar or
CENllID.
Now that "G" has been inserted, you must exit from the Editor before you can
execute the program. To exit from the Editor:
PRESS THE ESCAPE KEY (ESC) TWICE or
PRESS (lID once
71