Radio Shack TRS-80 Model 100 Basic Manual page 187

The process for determining other log-on sequences always follows this pattern. For
more specific instructions see "Creating an Auto Log-On Sequence" in your owner's
manual (p. 9l).
After this log-on sequence has been stored in the ADRS.DO file, you can access
TELCOM and press FIND
(CEIl)
to retrieve IS and then call the telephone number by
pressing CALL
(~).
After a few seconds, you'll be logged into the system and have
access to the News service.
This is an example of the kind of information you would get:
GOOD NEWS FOR M100 OWNERS:
IT WAS LEARNED THAT SEVERAL NEW VENDORS
HAVE RELEASED SOFTWARE PRODUCTS FOR THE
M100 PORTABLE COMPUTER. CONTACT THEM
DIRECTLY FOR MORE INFORMATION:
ABC SOFTWARE INC.
1234 ANYSTREET, NEW YORK, NY 00100
DEF MICROWARE
5678 SCENIC DR, COMPUVILLE, CA 14567
MACRoSoFT
8876 WONDER WAY, WETSVILLE, WA 88734
To log-off the system, type
BYE
(ENTER) or press CfI).
A log-off message, such as
THANK YOU FOR USING THE M100 USERS
BULLETIN BOARD SYSTEM
DISCONNECTING ••
may be displayed. Then TELCOM will display the prompt:
Disconnect?
Enter
CTI
to disconnect.
If
you enter CI), you will keep the telephone connected
and return to the Terminal Mode. If you disconnect the telephone, you will return to
the TELCOM system as evidenced by the prompt:
TelcoM:
Hints and tips...
When you first connect to a computer system, you might notice either of two strange
things happen on the display. You might, for instance, see nothing display as you type
on the keyboard. This would happen if you have the Model 100 set for Full Duplex
and the remote system is set for Half Duplex.
If
this happens, press
~
to toggle
from Full to Half Duplex.
181