Table of Contents
Advertisement
,
LEAR SIEGLER, INC.
DATA PRODUCTS DIVISION
SECTI~DN
II
INSTALL,ATION
2.1 GENERAL
Installation procedures involving unpacking, site
requirements,
initial
set-up,
and
operation
checkout of the ADM 3A are contained in this
section of the manual.
2.2 SPECIAL SAFETY REQUIREMENTS
No special safety requirement.s are imposed;
observe normal safety procedures when installing
the ADM 3A.
2.3 UNPACKING AND INITIAL
INSPECTION
Each ADM 3A is thoroughly inspected and
carefully packaged prior to shipment. Every
precaution is taken to ensure that each unit is
complete and ready for installation at the
customer's site. However, it is recommended that
each unit be inspected upon receipt for transit
damage. Start by examining the exterior of the
package for evidence of rough or careless
handling. Then perform a thorough visual
inspection of the internal components and
subassemblies. As a rule, most transportation
companies will not honor claims for damage
unless they are filled promptly; therefore, the
following steps should be taken:
1.
Verify that each item shown on the sales
order packing slip has been included in the
shipment. Contact LSI or your distributor
immediately
in
the
event of packing
shortage.
2. Check to verify that the serial number of the
unit corresponds to that shown on the
invoice.
3. Check the hardware to determine whether
any assemblies or screws were loosened
during shipment. Tighten as required.
2-1
4. Inspect for dust or foreign material which
may impair electrical contact when cable
connections are made. Vacuum to remove
any loose dirt.
6. Install and test operation of the ADM 3A as
soon as possible after delivery. (This is very
important since internal damage to the
equipment cannot be determined by visual
inspection alone.)
6. If, in your opinion, the equipment has been
damaged (either internally or externally),
notify the agent of the transportation
company
immediately
and
request
an
inspection. If assistance is needed to describe
the extent of the damage or the repairs that
will be necessary, contact your local sales
and service office.
2.4 SITE REQUIREMENTS
The ADM 3A may be used conveniently in a
normal
office
environment because
special
mounting provisions are not required. However, it
is recommended that a weather-protected
environment with an ambient temperature range
of 41°F to 122°F (5°C to 50
C
C) and relative
humidity of less than 95 percent be maintained for
equipment use.
To prevent condensation from
developing, allow the ADM 3A to
temperature stablize when changing
locations.
Condensation could
develop in the unit and adversely
affect the operation of the device.
Advertisement
Table of Contents
