Introduction For Buttons On Remote Controller; Start/Stop Button; Fan Auto Button; Mode Button - Friedrich MWM09Y1J Service Manual

Press this button to turn on the unit .Press this button again to turn off the unit.
Press this button to decrease set temperature. Hold it down for 2 seconds or more to rapidly decrease set temperature. In AUTO mode,
set temperature is not adjustable.
Press this button to increase set temperature. Hold it down for 2 seconds or more to rapidly increase set temperature. In AUTO mode, set
temperature is not adjustable.
This button is used for setting Fan Speed in the sequence that goes from AUTO,
Each time you press this button, a mode is selected in a sequence that goes from AUTO,COOL,DRY, FAN,and HEAT , as the following:
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not be displayed on the LCD, and the unit will
automatically select the suitable operationn mode in accordance with the room temperature to make indoor room comfortable.
Press this button to turn on SENSOR(SAVE) function. Saves room ambient temperature and automatically adjusts maintaining that
room ambient until pressed again which cancels the SENSOR(SAVE) function.
Pressing CLOCK button,
seconds increases or decreases the time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During
blinking after setting, press CLOCK button again to confirm the setting, and then
Press this button to initiate the auto-ON timer. To cancel the auto-timer program, simply press this button again.
After pressing this button,
to adjust the time value. Every press of either button changes the time setting by 1 minute. Holding down either button rapidly changes
the time setting by 1 minute and then 10 minutes. Within 5 seconds after setting, press TIMER ON button to confirm.
Press this button to set up & down swing angle, which circularly changes as below:
This remote controller is universal. If any command
guide louver swings as:
Pressing EXTEND button in COOL or DRY mode, the icon
order to dry the indoor unit even though you have turned off the unit.
After energization, EXTEND OFF is defaulted. EXTEND is not available in AUTO, FAN or HEAT mode.
By pressing this button you can display th e indoor setting temperature or indoor ambient temperature.When the indoor unit is first
powered on it will display the setting temperature, if the temperature's display status is changed from other status to"
ambient temperature, 5s later or within 5s, it receives other remote control signal that will return to display the setting temperature. if the
users haven't set up the temperature displaying status,that will display the setting temperature.(This function is not applicable
for some models).
Press this button to initiate the auto-off timer. To cancel the auto-timer program, simply press the button again.TIMER OFF setting is the
same as TIMER ON.
Technical Information
Auto
Low speed
AUTO COOL DRY
Note: Only for models with heating function.
blinks. Within 5 seconds, pressing + or - button adjusts the present time. Holding down either button above 2
disappears and " ON " blinks. 00:00 is displayed for ON time setting. Within 5 seconds, press
no display
(horizontal louvers
stops at current position)
,
Medium speed
High speed
FAN HEAT
will be constantly displayed.
or is sent out, the unit will carry out the command as
is displayed and the indoor fan will continue operation for 10 minutes in
, , to , then back to Auto.
or button
. indicates the
",displays the