Operation; Setting The Fan; Intensive Setting; Automatic Mode - Bosch DWB121K50 Instruction Manual

Operation

Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Explanation
Switches the fan on/off
#
Switches on automatic mode
>
1 Switches on fan setting 1
2 Switches on fan setting 2
3 Switches on fan setting 3
Switches on intensive mode 1
C
Switches on intensive mode 2
D
Switches on the fan run-on
+
Resets the metal grease filter saturation indicator
E
Resets the activated charcoal filter saturation indica-
F
tor
Switches on the lighting
B

Setting the fan

Note: Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on
Press the button.
#
1.
The fan starts in fan setting 2.
Press button 1, 3 or the
2.
another fan level.
Switching off the appliance
Press the button.
#

Intensive setting

You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Switching on
Press the C button.
1.
Intensive mode 1 is activated.
Press the button.
D
2.
Intensive mode 2 is activated.
Note: The run time of the intensive mode is
approx. six minutes. Once this time has elapsed, the appliance
switches back to a lower fan setting.
14
or button to set
C D
Switching off
Press button 1, 2 or 3.
The intensive mode ends.

Automatic mode

Switching on
Press the button.
#
1.
The fan starts in fan setting 2.
Press the > button.
2.
The optimum fan setting 1, 2 or 3 is set automatically using a
sensor.
Switching off
Press button 1, 2, 3 or the
Automatic mode is switched off.
The fan switches off automatically if the air quality in the room
falls below a certain level. Automatic mode can run for a
maximum of four hours.

Sensor control

In automatic mode, a sensor in the extractor hood detects the
intensity of the cooking and roasting odours. Depending on the
sensor setting, the fan automatically switches to another fan
setting.
Default sensitivity setting:
Lowest sensitivity setting:
Highest sensitivity setting:
Changing the sensitivity of the sensor
If the sensor control reacts too quickly or too slowly, change
the sensitivity setting.
When the fan is switched off, press and hold the
1.
approx. four seconds.
The setting is displayed.
Press button 1, 2, 3 or the
2.
change the sensitivity setting.
Press and hold the button for approx. four seconds.
>
3.
The change is saved.
button.
#
(fan setting 3)
„
(fan setting 1)
‚
(fan setting )
† D
>
or button to
C D
button for