Page 1
This manual has important safety warnings and operating information. Please read before using the dehumidifier and save for future reference. PURCHASE DATE: ________________________ SERIAL NO: _____________________________ DEALER: _________________________________________________________________________ DRI-EAZ PRODUCTS, INC. 15180 Josh Wilson Road Burlington, WA 98233 (360) 757-7776 • www.dri-eaz.com 07-00265 10/98...
Keep Out of Water Congratulations on your selection of a new Driz- Air 2400 Dehumidifier from Dri-Eaz Products Inc. It is Do not place the dehumidifier in standing or run- our goal to offer you the best high performance dehu- ning water.
If the dehumidifier is not working as it should, re- upon Dri-Eaz Products' examination, to be defective. turn it to Dri-Eaz or take it to a trained service person The foregoing constitutes the entire warranty and no for repair. For information about authorized repair and other warranty, liability, contingency or responsibility, maintenance, call Dri-Eaz at (360) 757-7776.
An automatic control built into the coil. This air is cooled by the evaporator coil, resulting DrizAir 2400 allows ice to build up until it starts to in condensation forming on that coil. This condensa- create an adverse effect on airflow through the unit.
After this, the amount of moisture removed Caution from the air will be considerably less. When operating the DrizAir 2400 on a hardwood floor, The decreasing amount of moisture being extracted it is suggested that the floor surface be protected due to indicates that the dehumidifier is doing its job and that possible minor leakage from the unit.
Under no circumstances should the 2. Plug in the DrizAir 2400 into a 110/120 volt outlet. unit be left operating. As the length of cable increases, On the touch-pad control, the red pin-light located the voltage available at the unit decreases.
8. If the DrizAir 2400 shuts off for any reason, allow at the top of the filter and work down. Allow the filter five minutes before restarting to avoid compressor to drain dry before reinstalling it in the filter shroud.
Need help?
Do you have a question about the DRIZAIR 2400 and is the answer not in the manual?
Questions and answers