Advertisement
CLEARANCES ANd dImENSIoNS
• Dimensions that are shown in Figure 1 must be used. Given
dimensions provide minimum clearance. Locate electrical
outlet in the shaded area in the upper left-hand corner of the
cutout. See Figure 7.
• Contact surface must be solid and level. Pay special attention
to the floor on which the Microwave Drawer will sit. The
floor of the opening should be constructed of plywood strong
enough to support the weight of the oven (about 100 pounds).
24" mICRoWAvE dRAWER mEASUREmENtS
11
4
/
"
16
3
1
/
4
4"
7
15
/
"
8
23
Figure 2
5
21
/
"
8
"
15"
auto drawer
opening
21
/
9
64
door thickness
7
/
"
8
• Check location where the Microwave Drawer will be
installed for proper electrical supply.
• Your oven can be built into a cabinet or wall by itself or
under a gas or electric wall oven.
• Be sur e that the clearance of the floor between the wall oven
and the microwave drawer is a minimum of 2-inches.
Figure 1
Figures 1 and 2 contain many Microwave Drawer measurements
for reference when planning the drawer's location.
This Microwave Drawer can be installed below any electric
or gas wall oven.
19
14
/
"
32
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord can
reach. Power cord access hole in cabinet should be a minimum
1
/
" diameter hole and deburred of all sharp edges.
1
2
7
/
"
8
IMPORTANT
electrical outlet to prevent tension.
"
Always check electrical codes for requirements.
2
Always allow sufficient power cord length to the
Advertisement
