Panasonic CF-37 Series Toughbook Reference Manual page 50

Dealing With Problems
Connecting Peripherals
Your peripheral does not
work (An error occurs while
installing the driver)
Unable to print
The cur sor does not
move from mouse opera-
tions
The device connected to
the serial port does not
work
E x t e r n a l m o u s e o r
trackball connected to
the external keyboard/
mouse por t does not
work
A PC Card does not work
You do not know the
available RAM module
The RAM module has not
been recognized
The address map for
IRQ, I/O port address,
etc. is unclear
A USB device does not
work
IrDA does not work
Some devices do not
work
(Advanced)
You need to use drivers conforming to the current operating system.
Some earlier drivers will no longer work.
For more information, please ask the manufacturer of the driver in question.
Check the computer-printer connection.
Make sure the printer is on.
Make sure the printer is in the online state.
Make sure paper is in the printer tray and there is no paper jam.
Confirm that [Parallel Port] has not been set to [Disable].
Check your mouse connection, then reboot the computer from the keyboard.
From the keyboard, you may choose to press down on
Down].
Check the connection.
Confirm that the device driver for the serial port works. Please refer to the refer-
ence manual of the device.
Confirm that two mouse devices are not connected, one through the external
keyboard/mouse port and the other through the serial port.
Try setting [Touch Pad] to disable in the Setup Utility.
Confirm that [Serial Port A] has not been set to [Disable].
Try setting [Touch Pad] to disable in the Setup Utility.
In some circumstances, if a PS/2 external mouse with a serial interface conver-
sion function is connected to the port, it may not operate normally. Try connecting
it to the serial por t.
Make sure the card is properly inserted.
Confirm that the card conforms to the PC Card Standard.
Note that after a driver is installed, the computer must be rebooted.
Check that the proper port settings have been made.
Read the PC Card's manual. Or, you may need to call the manufacturer of the PC
Card.
When [Card Executive 2.0 for NT] is not displayed in [Control Panel], install Phoe-
nix Card Executive™ 2.0 for Windows NT
Confirm that a PC card compatible with Windows NT is being used.
Press F9 in the Setup Utility (
page 31
Make sure the RAM module has been properly inserted.
Use the RAM module that support the recommended specifications.
Select [Start] - [Programs] - [Administrative Tools] -[Windows NT Diagnostics] to see
the present conditions.
USB devices are not supported.
Separate communications software is necessary.
The touchscreen function and Infrared can not be used simultaneously.
Infrared is disabled when using the default settings. To be able to use Infrared,
the setup of the device is needed.
Press F9 in the Setup Utility (
®
.
page 36).
page 36).
50
, then select [Shut