Table of Contents
Advertisement
Installation Manual
Quidway S3526 Ethernet Switch
Set the baud rate to 9600, the data bits to 8, parity check to none, stop bit to 1, flow
control to none, and terminal emulation to VT100. The specific means is as follow:
1)
Click [Start/Program/Accessories/Communications/Hyper Terminal] to enter the
Hyper Terminal window in which click icon
and the system will pop up the connection description interface.
Figure 5-2 Connection description interface of HyperTerminal
2)
Key in the name of the new connection in the connection description interface and
click <OK>, the system will pop up the following interface picture. Select the serial
port to be used from [Connect using].
Chapter 5 Booting and Configuration
to establish a new connection
5-2
- Quick Links:
- Brief Introduction to S3526 Switch
Hide quick links:
Advertisement
Table of Contents
