DCS 50si General Description Manual page 30

Digital communications system
Table of Contents

Advertisement

CALL WAITING/CAMP-ON
Busy stations are notified that a call is waiting (camped-on) when they receive a
tone. The tone is repeated at a programmable interval. Keysets receive an off-hook
ring signal through the speaker and single line stations receive a tone in the hand-
set. The volume of the camp-on tone can be set by the station user. Camped-on
calls follow Forward No Answer if a Forward No Answer destination has been set.
CENTREX/PBX USE
CENTREX and PBX lines can be installed in lieu of central office trunks. CENTREX
and PBX feature access codes including the command for hook-flash (FLASH) can
be stored under one touch buttons. Toll restriction programming can ignore PBX or
CENTREX access codes so that toll calls can be controlled when using these ser-
vices.
CHAIN DIALING
Keyset users may manually dial additional digits following a speed dial call or chain
together as many speed dial numbers as are required.
CLASS OF SERVICE
The system allows a maximum of 30 station classes of service. Each class of
service can be customized in memory to allow or deny access to features and to
define a station's dialing class. Each station can be assigned different classes of
service for day and night operation.
COMMON BELL CONTROL
Each MISC card is equipped with three programmable relays. A relay program-
mable relays. A relay programmed as a common bell provides a dry contact pair to
control a customer-provided bell or common audible device. These contacts must
be programmed as members of a station group and may provide steady or inter-
rupted closure.
CONFERENCE
The system allows six simultaneous conferences.
ADD-ON (5 PARTY)
Any combination of up to five parties (stations or outside lines) can be joined to-
gether in an add-on conference. Parties may be eliminated or added after a confer-
ence has been established.
UNSUPERVISED
A station user may set up a conference with two or more outside lines and then exit
the conference leaving the outside lines connected in an unsupervised (trunk to
trunk) conference.
4.1.7
CONTENTS

Advertisement

Table of Contents
loading

Table of Contents