Mowing Tips; Starting And Stopping; Over Work Protection; Emptying The Grass Collector - sunjoe MJ420C Operator's Manual

Mowing Tips

Before mowing ensure the area to be cut is clear of stones or
other objects, which may damage the mower or cause injury.
Start by mowing around the edges of your lawn, then cut
the center area in stripes. (Fig. 15) Mow twice a week during
growing season, the grass will be weakened if more than a
third of the length is cut away at one time. The mower should
be parked, the operation lever released and the blades allowed
to stop before the grass collector is removed for emptying.
Do Not Overload the Mower
If you hear the motor in the mower change pitch dramatically
while mowing, it may be overloaded.
If the grass is very thick or long, a first cut with the cutting
height set higher will help reduce the load on the motor.
(See Cutting Height section on page 6)
Fig. 15

Emptying the Grass Collector

Before removing the grass box for emptying, release the
operation lever and wait for the blades to stop turning.
1. Lift the basket up and toward the mower to release the
hooks.
2. Lift up and clear of the mower. Always empty clippings
before storage.
3. Replacing the grass collector is the reverse of the
removal process.
Starting & Stopping
The handle is designed with a safety button to prevent
accidental starting.
1. Press and hold the safety button 'A' located on the left
of the upper handle, then squeeze the operation lever
'B' towards the upper handle. You can now release the
safety button (A) and Start Mowing (Fig. 16)
Electric Lawn Mower
Electric Lawn Mower
Model No. MJ403E
Fig. 16
2. Release the operation lever 'B' to stop the mower.
(Fig. 17)
Fig. 17
m
IMPORTANT
: When releasing the operation lever,
wait for the blades to stop turning before clearing any grass or
putting your hands near the blades!

Over Work Protection

The reset button 'C' (Fig.17) on the switch box is to prevent
any damage occurring to the battery or the motor due to a
current overload, such as from the blade jamming. If the load
exceeds its capacity the reset button will pop out and stop the
power supply to protect the mower and blades.
To restart the mower
Ensure the blades are clear of debris, wait for a few seconds,
then press the reset button.
Please Note: Cutting long, thick, or wet grass could overload
the mower or make the blade stall. If the over work protection
7
Form No. SJ-MJ403E-XXXE
OPERATOR'S MANUAL