sunjoe MJ420C Operator's Manual page 4

Assembly
1. Fit the Lower Frame onto the two large lugs on the
Main Unit. Fit one side and then flex the other side of
the frame until it fits over the opposite lug. (Fig. 2 and
Fig. 3)
Fig. 2
Fig. 3
2. To assemble the Upper Frame to the 2 Middle Frame
parts. Hold the Upper Frame so that the Safety Lever
faces downward, insert the Middle Frame sections so
that they bend outwards and the holes are aligned.
Insert the 2 short bolts from the top so that the nut is
underneath the frame then secure each one. (Fig. 4)
Fig. 4
3. Use 4 nuts and 4 long bolts to hold the upper and
middle sections in place on the Lower Frame. Insert
the bolts from the outside and fit the nuts on the
inside of the frame. (Fig. 5)
Fig. 5
4. Once the frame is assembled, connect the plug on the
handle cable to the socket on the main unit. Tighten
the screw ring to secure the cable. (Fig. 5)
5. Secure the cable to the handle using the 3 cable clips,
leave some slack on the cable to allow free movement.
(See Fig. 1, Pg. 3)
6. To fit the Grass Collector position the hooks onto the
rear roller axle of the Main Unit. (Fig. 6)
Fig. 6
Please Note: Open grass collector fully by locking
brackets in a straight position.
4