Coffee Brewing - Bunn Omni Installation & Operating Manual

Table of Contents

COFFEE BREWING

1. Insert a ﬁ lter into the funnel. BUNN

2. Pour the proper amount of fresh ground coffee into the ﬁ lter and level the bed of grounds by gently shak-

ing.

3. Slide the funnel into the funnel rails, the arrow on the funnel handle towards the front of the brewer pointing

towards the left, for brewing into the rear reservoir, or with the arrow pointing to the right, for brewing into

the front reservoir.

4. Press the appropriate button, either LEFT or RIGHT to start the brew cycle.

5. When the brew cycle is complete, the DISPOSE GROUNDS indicator light will be illuminated. Dispose of used

grounds to reset the indicator. The (red) LEFT or RIGHT LOW indicator for the reservoir brewed into should

be extinguished.

NOTE: In order for the LEFT, RIGHT, and CLEAN switch to actuate on the Manual Control machines, the lower

"Hidden" switch to the right of the "RIGHT" switch must be pressed and held.

AUTOBREW

The brewer can be staged to automatically start a brew cycle when a reservoir reaches a low level.

1. Repeat steps one through three above. When the appropriate button is pushed to start the brew cycle, the

green AUTOBREW ON indicator will light.

2. When the reservoir for which the brew cycle has been selected reaches the low level, the brew cycle will

automatically start, and the AUTOBREW ON indicator will reset.

3. To cancel the AUTOBREW mode before the brew cycle begins, remove the funnel from the brewer.

part number 20138.0000 (Gourmet) or equivalent.

CLEAN

LEFT

OFF

LEFT LOW

CLEAN TONIGHT