Safety Instructions - AKG CSX IRS10 User Manual

10 channel infrared system
Table of Contents

Advertisement

Safety Instructions

Do not place any containers containing liquid on the device or the powerpack
Do not spill any liquids on the equipment and do not drop any objects through the
ventilation slots in the equipment.
Use the equipment in dry rooms only. Do not expose the equipment to rain or splash
water. Never place objects containing liquids (e.g., vases) on or near the equipment.
There are no user-serviceable parts inside the equipment. Do not attempt to service the
equipment yourself. Refer all servicing to qualified personnel. Opening the chassis for any reason
will void the manufacturer's warranty.
Before connecting the equipment to power, check that the AC mains voltage stated on the
power supply included with the equipment is identical to the AC mains voltage available where
you will use the equipment. Also check that the power outlet is a standard type with a protective
ground connection. Disconnecting the protective ground lead or using non-standard power plugs
or non-standard power outlets is illegal.
Operate the equipment only with the included or required power supply. Using a different
power supply may cause serious damage to the unit.
If any solid object or liquid penetrates into the equipment, shut down the system
immediately. Disconnect the equipment from power immediately and have the equipment
checked by AKG service personnel.
If you will not use the equipment for a long period of time, disconnect the equipment from
power. Please note that the equipment will not be fully isolated from power when you set the
power switch to OFF.
Disconnect the equipment from power during storms to prevent damage.
Make sure to route power supply cords so that they are not likely to be walked on or
pinched by items placed upon or against them, paying particular attention to cords at plugs,
convenience receptacles, and the points where they exit from the equipment.
To avoid hum or interference, route all audio lines, particularly those connected to
microphone inputs, away from power lines of any type. If you use cable ducts, be sure to use
separate ducts for the audio lines.
Make sure to replace each built-in fuse with a standard fuse of the same type and rating
only. Using any other type of fuse may cause excessive heating and/or a risk of fire.
Never switch more than twenty microphone stations on simultaneously because the
resulting current drain may cause a risk of fire.
CSX IRS10 Manual V1.1
3 / 32

Advertisement

Table of Contents
loading

Table of Contents