Meridian DSP5000 User Manual page 44

If a power-line filter is to be used, try to use a permanent type, and be
sure that it is approved to the standards of your territory and that it
retains the grounding
WARNING: DSP5000 must be grounded.
Connection using M5- and S5-leads
Many systems will require only the supplied composite M5- and S5-leads.
If these are not appropriate, further information can be found in the
section starting on page 46.
To get a CD player working with the DSP5000s, proceed as follows:
1. Locate the cable marked with 'S5'. This is a DIN + Phono to DIN +
Phono lead, about 6m long.
2. Connect one DIN plug to the Comms Input socket and the
accompanying phono plug to the D1 socket on the slave DSP5000.
3. Connect the other end to the Comms Output socket and the D OUT
socket of the master.
This completes the interconnection of the DSP5000 pair. Now:
4. Locate the cable marked with 'M5'. This is a DIN + Phono to DIN +
Phono lead, about 8m long.
5. Locate the end with the single DIN and phono plug. Connect this DIN
plug to the Comms Input socket and the phono plug to the D1 socket
on the master.
6. At the other end of this cable, locate the phono plug and connect it to
the digital output of the CD player.
Note Getting this far should provide you with audio, and further
connections will give you control of any Meridian products in your system.
For connection of Meridian Comms, see page 46.
Connecting DSP5000
DSP5000 User Guide
44