How To Use Config; Root Menu Options; System Menu - Meridian DSP5000 User Manual

Inside Config you can move between them at will. To go to
1. root: press Clear
2. system: press Off
3. source: press a source key – e.g. CD
Note In Config, the speaker is silenced.

How to use Config

1. Switch off the master DSP5000, using the power switch on the back,
and wait for 3 seconds
2. While pressing the 0 key on the remote control, switch the power on
again. The display will indicate the root menu that shows the left/right
and master/slave settings; for example,
r.
indicates a right master.
3. Release the 0 key

Root menu options

The root menu controls the overall operation of the DSP5000s, with
options for master/slave and left/right.
You get to the root menu by
1. Selecting Config, as above
or, at any stage in the Config programming process,
1. Pressing Clear or Off
Choosing left or right
To change a left speaker into a right speaker, or vice versa:
1. Press n n or s s on the remote control
Note If you have started with Type 6 or selected 'CEn.Y' elsewhere in
Config, then you also have the choices 'C' and 'S' for Centre and
Subwoofer. If you want the speaker to be a Centre in a 565-based
1
system, choose 'C'.
Choosing master or slave
To change a master to a slave, or back again:
1. Press Play on the remote control
r. S.
This display indicates a right slave.

System menu

To get into the system menu:
1. Press the menu e e key
Preamplifier options
The first digit in the system menu identifies the dominant preamplifier in
the system.
1
This choice also permits you to make the DSP5000 the system
subwoofer. This choice would normally be made only for diagnosis!
Customising using Config
DSP5000 User Guide
34