Kipor KDD03 Operation Instructions Manual page 8

Please read the Operation Instructions carefully for safety.
10) According to Rule for Labor Safety and
Health, machine must be provided with protective
cover if it is used for application that labor is
exposed to hazard such as falling stone. In such
dangerous situation, do not use machine without
protective covers.
11) To ascend an abrupt slope, select the
Backward and keep the loader stable. Drive the
loader slowly and lift the bucket about 20-40cm
above the ground. To descend a slope, select the
Forward and keep the loader stable. Drive the
loader slowly with bucket close to the ground.
12) Do not make a turn on a slope as much as
possible. Make a turn on the flat ground if
possible.
13) Drive the loader at the relatively low speed in
the confined space, room and place with stored
matters. Meanwhile pay attention to surrounding
conditions.
14) Consider the possibility of collapse when
loader moves along cliff or abrupt slope.
Strengthen it or take other appropriate measures
if necessary. It turns more dangerous after it
rained. Do not approach such places willfully and
position where stone may slide down.
15) Soft ground may catch tyres, leading to
imbalance. In such case, check the capacity of
ground before operation. If loader descends a
slope or slides to side and ground is soft, lower
the bucket immediately as brake.
16) When loader drives or brakes on the
snow-covered or frozen ground, skid or lateral
slippage may occur.
brake, start, rotation and other dangerous
actions. Front wheels are typically furnished with
anti-skid chains. In case of jobs under snowy
conditions or requiring traction, both front and
rear wheels must be fitted with anti-skid chains.
17) When speeding down a slope, do not brake
wildly.
Do not carry out quick
If pressing down the "low-speed securing" button,
speed descends and shifts rapidly when loader
drives at the high speed. Then rear section of
loader may be lifted a little and float. Sometimes
it causes danger. Reduce the rotation speed of
engine and shift slowly.
(1) Stop the engine when descending a long
slope. In such case, trigger the "low-speed
securing" button and brake of engine at the same
time.
(2) Operate the brake pedal for over-speed.18)
Do not operate the Stop Brake when loader is
running. Sudden stop is extremely dangerous.
19) It is very likely to happen that loader slides to
side or loses the balance in case of inclined
connection. It poses a great danger.
20) The steering wheel of loader is different from
that in car. It cannot return to original position
automatically after it is operated for turning.
Thus reset the steering wheel manually
21) If any tyre bursts, operate the loader as
emergency stop or lower the speed mildly but not
work the steering wheel in a hurry.
22) Goods may fall down to one side of cab if
loader operates unstable goods or jobs at a
relatively high level. Therefore do not lift bucket
too high or lean back when loader operates
unstable goods.
23) Turnover is very likely to happen due to
counterforce in case of abrupt descending or
emergency stop, particularly it is loaded.
24) Know positions of cable, gas pipe, running
water pipe, sewer and other underground
facilities before excavation.
25) Excavation under cliff is exposed to collapse,
falling stone and other possible great risks.
26) Indoor job may generate the waste gas and
cause toxic conditions.
ventilation for indoor jobs (in the shelter). Check
the loader outside in advance.
3
Ensure sufficient