Table of Contents
Advertisement
Customer Display 20x20
This test lets you adjust the LCD and VFD contrast and backlight controls of the 20x20
Customer Display.
To see the Firmware version of the Customer Display, tap the Firmware Info button.
Cash Drawer
This test lets you monitor the status of each cash drawer.
When you tap the Cash Drawer icon, the Cash Drawer Password Verification window
opens.
Apply the following formula to the six-digit number that appears in the Key field.
For example, if the Key is 532586, the password is 26. (5x3+5+6 = 26).
Enter the password, and the Cash Drawer utility opens.
RS232 Loopback
This test requires two RS232 ports on the Base Station to be connected together for
loopback testing. It opens the Output Port and Input Port in RS232 mode and
continuously transmits a sequence of characters from the Output Port.
RS232 Print
This test requires the Base Station to be connected to a Serial RS232 Roll Printer. It opens
an RS232 port on the Base Station and continuously transmits a sequence of print lines to
the Output Port.
IDN Loopback
This test requires the RS422 ports on the Base Station to be connected together for
loopback testing. It opens the Output Port in (+) mode and the Input Port in (-) mode and
continuously transmits a sequence of characters from the Output Port.
IDN Print
This test requires the Base Station to be connected to an IDN Roll Printer with an ID of 1.
It opens a RS422 (+) port on the Base Station and continuously transmits a sequence of
print lines to the Output port.
Battery Status
This test provides details and status information of the Base Station's optional battery
pack.
Hardware Monitor
This test determines or sets the COM2 port (DSUB) voltage, checks the optional battery,
and enables/disables the USB ports on the Base Station.
To select the DSUB Power voltage, tap the pull down, select the desired voltage (5V, 9V,
or 12V), and then tap the Write button. COM2 is fixed at 12V to support the MICROS
Integrated Mini Printer. To enable or disable, tap the drop-down and select On or Off.
Tablet and Base Station E-Series Diagnostics Utilities
Digit 1 x Digit 2 + Digit 4 + Digit 6 = Password
4-3
Advertisement
Table of Contents
