GMC Savana 2016 Owner's Manual page 44

4. Repeat this procedure for the
other pins.
5. Pull the seat rearward about
5 cm (2 in), and then lift the
seat from the floor rails.
6. Remove the seat from the
vehicle.
7. For the second and third row
seats, stow the safety belt latch
by attaching the clip on the
safety belt latch to the trim just
inside the side door.
For the last row of seats, stow
the safety belt latch plate on
the clip at the window trim. Roll
the mini-latch into the safety
belt webbing and then hook the
safety belt latch plate on
the clip.
Reinstalling the Rear Seats
Warning
A seat that is not locked into
place properly can move around
in a collision or sudden stop.
People in the vehicle could be
(Continued)
Seats and Restraints
Warning (Continued)
injured. Be sure to lock the seat
into place properly when
installing it.
Warning
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. After raising the
rear seatback, always check to be
sure that the safety belts are
properly routed and attached, and
are not twisted.
1. Position the seat into the open
slots in both rails. Push the
seat forward in the rail, hooking
both seat bases onto the pins
inside of the rails.
2. Locate the hole in the rail to
install the locking pins at the
rear of the seat base. If the
43