GMC Savana 2016 Owner's Manual page 240

2. Remove the two bolts from the
headlamp assembly.
3. Lift the headlamp assembly to
release the lower tabs from the
radiator support.
4. Turn the headlamp forward and
upward to remove it from the
grille.
5. Disconnect the electrical
connector.
6. Turn the bulb counterclockwise
one-quarter turn to remove it
from the headlamp assembly.
7. Install the new bulb into the
headlamp assembly and
connect the electrical
connector.
8. Reverse the steps to reinstall
the headlamp assembly.
To prevent headlamp vibration
and shortened bulb life, be
sure to insert the headlamp
Vehicle Care
assembly tabs in the slots at
the lower portion of the
housing.
Sealed-Beam Headlamp
1. Headlamp Retainer Screws
2. Headlamp Retainer
3. Sealed-Beam
Headlamp Bulb
To replace one of these bulbs:
1. Remove the four screws (1)
from the headlamp retainer (2).
Pull the retainer (2) out and set
it aside.
239