Advertisement
Step 3. Set up Scooba
1
Open both the Fill
and Empty Ports.
Slowly add warm
water in the Fill Port.
4
Place Scooba in the
middle of the dirtiest
area of the floor.
TIP: Use only Scooba Hard Floor Cleaner or tap water; other solutions may damage Scooba.
Step 4. Clean Scooba
1
Empty and thoroughly rinse both the Fill
and Empty Ports with water after each use.
TIP: To protect bottom plate brushes, keep Scooba on storage mat, when not in use.
© 2011 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730. All rights reserved. iRobot and Scooba are registered trademarks of iRobot Corporation. [00027.0111.v1]
iRobot Scooba 230 Quick Start Guide
2
Add Scooba Hard
Floor Cleaner (either
one pre-measured
packet or one-half
of a cap full).
5
Press the Power button
to turn on Scooba.
2
Take off the bottom plate. Rinse and
remove debris from brushes and
squeegee.
3
Firmly close the
Fill and Empty
Ports until
sealed.
6
For short cycle,
press and hold clean
until second song
plays. (20 minutes,
up to 60 sq. ft.)
For the long cycle, press clean once.
(45 minutes, up to 150 sq.ft.)
3
Remove any debris on the robot before
replacing the bottom plate.
www.irobot.com
CLEAN
power
Advertisement
