Before You Get Started
Clean With Scooba
Charge Scooba's Battery
With the Clean tank filled and properly installed, place Scooba in the center of the
room, press "Power" and then press "Clean." Scooba will begin a cleaning cycle.
Let Scooba clean until the tank is empty (approximately 45 minutes). Scooba's Clean
light will blink to indicate that it is almost finished cleaning and that Scooba is
drying its cleaning system. The drying mode lasts 5 minutes.
1
Clean Button Light
Green solid
Green blinking
Empty Scooba
3
1
Fill Scooba's Tank
1
Remove Scooba's tank.
4
Open Scooba's tank.
4
Remove and rinse
Scooba's filter.
Slowly fill the remainder of the
See the Owner's Manual for important tips and maintenance
Clean tank with warm or cold tap
water. Tilt the tank and ensure it is
completely filled to the top.
TIP: Scooba is designed to work with 7 ml of Scooba cleaning solution natural enzyme formula or
60 ml of white vinegar and water. You also can use Scooba with plain tap water.
© 2007-2009 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730. All rights reserved. iRobot and Scooba are registered trademarks of iRobot Corporation. [00007.0209.v1]
Instructional videos available at www.irobot.com/usetips
US Pat. Nos. 6,690,134 | 6,809,490 | 6,594,844. Other patents pending. Clorox is a registered trademark of The Clorox Company. All rights reserved.
Grasp the handle
and pull Scooba's
What It Means
tank up.
Cleaning
Scooba is drying
its cleaning head
When Scooba has completed a cleaning cycle,
empty and rinse Scooba's tanks.
Plug the Power Supply into
Scooba to charge the battery. For
best performance, iRobot recom-
mends charging Scooba's battery
2
overnight the first time only.
2
Open the Dirty and Clean
tanks and drain.
5
Lift the tank clear of the robot
and place the tank on a flat
surface.
5
Remove and clean Scooba's
cleaning head and brush.
Secure the tank cap and place
the tank back in the tank
holder.
instructions, or visit www.irobot.com
2
Place battery in Scooba by
rotating the battery into its
slot, making sure the tabs fit
inside the guide holes.
Power Button Light
Battery Status
Red
Battery empty
Green pulse
Charging
Green fast pulse
16-hour refresh charge
Green solid
Fully charged
3
Red blinking
Battery not installed
3
Rinse the Dirty and Clean
tanks with warm water.
6
Fill the Clean tank with water
and 7ml (1 capful or 1 packet)
of Scooba cleaning solution
natural enzyme formula or 60
ml of white vinegar.
6
Replace Scooba's tank.
Close the tank by pressing
down on the tank. You will
hear a click when the tank
is properly installed.