Hisense HR6TFF350 User's Operation Manual page 5

5
Model A
HR6TFF350(S) 1301
HR6TFF272(S) 1172
HR6TFF230(S) 1172
It may not work properly if being left at
a temperature above or below the
indicated range for a long period.
Climate class Ambient temperature
SN
N
ST
T
● Stand your appliance in a dry place to
avoid high moisture.
●
Keep the appliance out of direct
sunlight rain or frost. Stand the
appliance away from heat sources
such as stoves, fires or heaters.
Leveling of appliance
For sufficient leveling and air
●
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
suitable spanner.
To allow the doors to self-close, tilt
●
the top backwards by about 10mm.
Reversing the door
The side at which the door opens can
be changed, from the right side (as
supplied) to the left side, if the
installation site requires.
B C
960 740
938 670
938 670
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
≤10mm
Hisense Refrigerator
Warning! When reversing the door, the
appliance must not be connected to
the mains. Ensure that the plug is
removed from the mains socket.
Tools you will need
8mm socket wrench Cross-shaped screwdriver
Thin-blade screwdriver
Monkey wrench
Note: Before you start lay the
refrigerator on its back in order to
gain access to the base, you should
rest it on soft foam packaging or
similar material to avoid damaging
the backboard of the refrigerator. To
reverse the door, the following steps
are generally recommended.
1. Stand the refrigerator
Open the upper door to take out all
door racks (to avoid rack sdamaged)
and then close the door.
2. Stand the refrigerator upright, first
remove the screw cover ① and loose
the screw ②and unscrew the upper
hinge cover ③ which is at the top right
corner of the refrigerator, and use a
putty knife or thin-blade
to prize the screw hole cover ④ which
is at the top left corner of the
refrigerator.
8mm wrench
upright.
Door racks
screwdriver