Mitsubishi Colt Owner's Manual page 82

l When the ignition switch is switch-
ed from "ACC" or "LOCK" to
"ON", the mode setting is automat-
ically switched from manual to au-
to.
Switching to auto occurs automati-
cally. If switching to manual
mode is done, however, the data
from the last reset is displayed.
Auto reset mode
l When the average fuel consump-
tion is being displayed, if you hold
down the MODE/SET switch, the
average fuel consumption and aver-
age speed displayed at that time
are reset.
l If the ignition switch is at "ACC"
or "LOCK" for about 4 hours or
longer, the average fuel consump-
tion display is automatically reset.
NOTE
l "---" is displayed when the aver-
age fuel consumption cannot be
measured.
l The initial (default) setting is "Au-
to reset mode".
l The average fuel consumption de-
pends on the driving condition
(road condition, driving behavior,
etc.). The displayed fuel consump-
tion may vary from the actual fuel
consumption. Treat the fuel con-
sumption displayed as just a rough
guideline.
l The memory of the auto reset
mode or manual reset mode for
the average fuel consumption dis-
play is erased if the battery is dis-
connected.
l The display setting can be
changed to the preferred units
(L/100 km, km/L).
Refer to "Changing the function
settings (when the ignition switch
is "ON")" on page 3-12.
l For vehicles equipped with multi-
information displays that show fig-
ures in miles, the fuel consump-
tion can only be displayed in
miles per gallon ("mpg").
Average speed display*
E00521600744
This displays the average speed (km/h or
mph) from the last reset to the present
time.
There are the following 2 mode settings.
For the method for changing the average
speed display setting, refer to "Changing
the function settings (when the ignition
switch is "ON")" on page 3-12.
Manual reset mode
l
When the average speed is being
displayed, if you hold down the
MODE/SET switch, the average
speed and average fuel consump-
tion displayed at that time are reset.
Instruments and controls
l When the ignition switch is switch-
ed from "ACC" or "LOCK" to
"ON", the mode setting is automat-
ically switched from manual to au-
to.
Switching to auto occurs automati-
cally. If switching to manual
mode is done, however, the data
from the last reset is displayed.
Auto reset mode
l When the average speed is being
displayed, if you hold down the
MODE/SET switch, the average
speed and average fuel consump-
tion displayed at that time are reset.
l If the ignition switch is at "ACC"
or "LOCK" for about 4 hours or
longer, the average speed display
is automatically reset.
NOTE
l "---" is displayed when the aver-
age speed cannot be measured.
l The initial (default) setting is "Au-
to reset mode".
l The memory of the auto reset
mode or manual reset mode for
the average speed display is
erased if the battery is disconnec-
ted.
Allshift lever position display*
E00528100012
Shows the position of the allshift lever.
Refer to "Allshift lever position and mul-
ti-information display" on page 4-20.
3-09
3