Mitsubishi Colt Owner's Manual page 60

To install
1. Insert the child restraint system's connectors
(A) into the slit (B) in accordance with the in-
structions provided by the child restraint sys-
tem's manufacturer.
A- Connector
B- Slit
C- Vehicle seatback
D- Vehicle seat cushion
E- Lower anchorage
2. Remove the head restraint from the location
in which you wish to install a child restraint.
3. Latch the tether strap hook (F) of the child
seat to the tether anchorage bar (G) and tight-
en the top tether strap hook so it is securely
fastened.
4. Push and pull the child restraint system in all
directions to be sure it is firmly secured.
WARNING
l If there is any foreign material in or
around the connectors, remove it before
installing the child restraint system. Also,
make sure the seat belt is away from, not
looped through or otherwise interfering
with, the child restraint system. If foreign
matter is not removed and/or the seat
belt interferes with the child restraint sys-
tem, the child restraint system will not be
secured properly and could move for-
ward in the event of sudden braking or a
collision, seriously injuring the child and
possibly other vehicle occupants.
Seat and seat belts
WARNING
l When the vehicle is moving do not adjust
the seat where the child restraint system
is installed.
To remove
Remove the child restraint in accordance with the
instructions provided by the child restraint sys-
tem's manufacturer.
Installing a child restraint system to a
3-point type seat belt (with emergency
locking mechanism)
E00408700529
Front passenger seat
Installation:
1. Fasten the seat belt to secure the child re-
straint system.
Make sure you hear a "click" when you in-
sert the latch plate in the buckle.
2. Remove all slack by using the locking clip.
3. Push and pull the child restraint in all direc-
tions to be sure it is secure.
2
2-21