Table of Contents
Advertisement
Setting daytime running lamp mode
(USA only)
i
This function is not available in countries
where the daytime running lamp mode is manda-
tory and therefore in a constant mode.
Move the selection marker with button
æ or ç to the
Lighting
menu.
Press button j or k repeatedly
until you see this message in the left
multifunction display:
Light Circuit
Headlamp Mode
.
The selection marker is on the current
setting.
Press button æ or ç to select
manual operation (
Manual
) or daytime
running lamp mode (
Constant
activated.
With daytime running lamp mode activated
and the exterior lamp switch in
position M or U, the low-beam
headlamps are switched on when the
engine is running.
In low ambient light conditions the
following lamps will switch on additionally:
sub-
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
For more information on the daytime
running lamp mode, see "Daytime running
lamp mode" ( page 108).
i
For safety reasons, resetting the Lighting
submenu to factory settings while driving
( page 129) will not deactivate the daytime
running lamp mode.
You see the following message in the right multi-
function display: Cannot be fully reset to
factory settings while driving.
)
Controls in detail
Control system
Setting locator lighting
With the locator lighting feature activated
and the exterior lamp switch in
position U, the following lamps will
switch on during darkness when the
vehicle is unlocked with the SmartKey:
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
Front fog lamps
The locator lighting switches off when the
driver's door is opened.
If you do not open a door after unlocking
the vehicle with the SmartKey the lamps
will switch off automatically after approxi-
mately 40 seconds.
135
Advertisement
Table of Contents
