Gearshifting Malfunctions - Mercedes-Benz 2009 M-Class Operator's Manual

X
Unscrew filler cap from filler neck.
1
X
Add engine oil as required. Be careful not
to overfill with oil.
Be careful not to spill any oil when adding.
Avoid environmental damage caused by oil
entering the ground or water.
! Excess oil must be siphoned or drained
off. It could cause damage to the engine
and emission control system not covered
by the Mercedes-Benz Limited Warranty.
X
Screw filler cap back on filler neck.
1
For more information on engine oil, see the
"Technical data" section ( Y page 411) and
( Y page 414).
Transmission fluid level
The transmission fluid level does not need to
be checked. If you notice transmission fluid
loss or gearshifting malfunctions, have an
authorized Mercedes-Benz Center check the
transmission.
Coolant level
The engine coolant is a mixture of water and
anticorrosion/antifreeze.
When checking the coolant level, the vehicle
must be parked on level ground, and the
coolant temperature must be below 158‡
(70†).
G Warning!
In order to avoid any potentially serious
burns:
Use extreme caution when opening the
R
hood if there are any signs of steam or
coolant leaking from the cooling system,
or if the coolant temperature indicator
indicates that the coolant is overheated.
Do not remove pressure cap on coolant
R
reservoir if coolant temperature is above
158‡ (70†). Allow engine to cool down
before removing cap. The coolant
reservoir contains hot fluid and is under
pressure.
Using a rag, slowly open the cap
R
1
approximately / turn to relieve excess
2
pressure. If opened immediately,
Engine compartment
scalding hot fluid and steam will be blown
out under pressure.
Do not spill antifreeze on hot engine
R
parts. Antifreeze contains ethylene
glycol which may burn if it comes into
contact with hot engine parts.
Marking bar in the expansion tank
1
Cap
2
Coolant expansion tank
3
X
Using a rag, turn cap slowly
2
1
approximately / counterclockwise to
2
release any excess pressure.
X
Continue turning cap counterclockwise
2
and remove it.
Operation
Z
243