Menu; Telephone - Mercedes-Benz 2009 M-Class Operator's Manual

M-class
Hide thumbs Also See for 2009 M-Class:
Table of Contents

Advertisement

If only very little fuel is left in the tank, a
vehicle at the fuel pump
¿
instead of the remaining driving range.
Telephone menu
G Warning!
A driver's attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking
a telephone call. If you choose to use the
telephone while driving, please use the
hands-free device and only use the
telephone when weather, road and traffic
conditions permit.
Some jurisdictions prohibit the driver from
using a mobile phone while driving a
vehicle.
Bear in mind that at a speed of just 30 mph
appears
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
Never operate radio transmitters equipped
with a built-in or attached antenna (i.e.
without being connected to an external
antenna) from inside the vehicle while the
engine is running. Doing so could lead to a
malfunction of the vehicle's electronic
system, possibly resulting in an accident
and/or personal injury.
You can connect your telephone to the
COMAND system via Bluetooth
separate COMAND system operating
instructions.
X
Switch on the COMAND system.
Refer to separate COMAND system
operating instructions.
X
Press button
the message TEL appears in the
multifunction display.
One of the following messages will appear
in the multifunction display:
®
, see
or
repeatedly until
ÿ
è
Controls in detail
Control system
No Service: No network is available.
R
Bluetooth Ready: The telephone has
R
not been connected to the COMAND
®
system via Bluetooth
yet.
X
Connect the telephone to the
COMAND system via Bluetooth
Ready or name of the network provider
R
(if available): The telephone has found a
network and is ready for use. You can
operate it using the control system.
Answering a call
When your telephone is ready to receive calls,
you can answer a call at any time. In the
multifunction display you will then see the
following message, or if available, the caller
ID (number or name):
X
Press button s.
You have answered the call.
®
.
Z
161

Advertisement

Table of Contents
loading

Table of Contents