Electronic selection -Tanked or mains plumbed ......................... 5 Operation with Internal Tank ............................. 6 ..........................6 REPARING THE ESUVIUS FOR OPERATION Filling the Vesuvius for the first time..........................6 Flushing the Vesuvius before using ............................ 6 ..................... 7 ESCRIPTION OF THE MAJOR CONTROLS OF THE ESUVIUS Understanding the display &...
Inspection and unpacking further for safe operation After having removed the packaging, make certain that the Vesuvius is not damaged in any way. If you have any doubts, do not use the Vesuvius and contact a professionally qualified person or your dealer.
4 in total. Note: they are NOT on the top. The Vesuvius is secured to the base using rubber 2. The sides of the crate are secured by 4 transit feet with bots on the bottom that protrude...
Mains Water Connection Routing the safety pressure release vent valve to the water tank, protects both you and the machines The Vesuvius is supplied ready for a mains water electronics if a fault causes any high pressure connection or internal tanked operation.
The pump should not run during this process. Switch the Vesuvius on, allow the service boiler to refill and 2. Switch on the machine at the mains and repeat this process.
Touch this screen anywhere to move to the profile menu The display above shows the Vesuvius on standby. Touching the area marked with a red circle, switches the machine on and the "home screen" is shown (below). Main menu for...
Steam (above) might be highlighted, but if the steam function is not switched on, nothing happens and the steam boiler will not heat. The Vesuvius will not enter ECO mode, as the "Eco Steam function" only operates when the steam boiler is on.
4 minutes. This keeps the Vesuvius cooler and gives a The Internal Eco timer starts counting down to 0 very rapid warm up to full steaming temperature.
The tip above is for the times when you want to brew a coffee and not necessarily steam milk. Once you have finished, you may decide to put the Vesuvius straight back into Eco mode. Again if it helps think of this fairly quick procedure as: •...
Page 14
Does nothing, touch + to continue This The Vesuvius has an internal On/Off actually timer, with 2 on/off times each day, 7 shows E61 days per week. It can be ready in the group lever morning, off during the day and back on operations again when you return from work.
This screen tells us that for the 1st phase (of the 7 This screen shows the 5 profiles available and a phases available), the Vesuvius will deliver a home icon. To program or view a profile, simply pressure of 2.0 bar for 10s. A global Pump touch one of the 5 profile icons for 5 seconds.
2 bar due to low flow rates from the pump. One of the reasons the Vesuvius always supplies the pump from it's internal tank, is to allow preinfusion pressures lower than mains line pressure (usually much higher than 2 bar).
The Vesuvius is able to use a grind much finer than repeatable control, well beyond that of any lever standard espresso machines and the less expensive machine.
Pressure profiling 5 profiles can be saved each with up to 7 stages. Last shot protection The Vesuvius will always complete the last shot, even if water is low M&V S.r.l. Via L. Guerra, 9 80040 Cercola (NA) Ph./Fax +39 0815552428...
• Replace a heating element (with dealer screen. guidance) The Vesuvius should only be cleaned with non abrasive cleaners and a soft micro-fibre (recommended), cloth In the event of any abnormal operation or problem with the display or main computer: Switch the machine off and unplug it.