Trouble Shooting - Hitachi L26VG07U Instruction Manual

Trouble shooting

Image persistence - ghosting
Please note that ghosting may occur while displaying
a persistent image (still or paused image). LCD TVs'
image persistence may disappear after a short time.
Try turning off the TV for a while. To avoid this, do not
leave the screen in still picture mode for extended
periods.
No power
If your TV has no power, please check the power cord
plug is connect to the mains power socket.
Poor picture
1. Have you selected the correct TV system?
2. Is your TV or house aerial located too close to
a non-earthed audio equipment or neon lights,
etc.?
3. Mountains or high buildings can cause double
pictures or ghost images. Sometimes you can
improve the picture quality by changing the
direction of the aerial. Is the picture or teletext
unrecognisable?
4. Check if you have entered the correct
frequency.
5. Please retune the channels.
6. The picture quality may degrade when two
devices are connected to the TV at the same
time. In such a case, disconnect one of the
devices.
No picture
1. No Picture means that your TV is not receiving
a transmission. Have you selected the correct
button on the remote control? Try once more.
Also make sure the correct input source has
been selected.
2. Is the aerial connected properly?
3. Are the plugs connected tightly to the aerial
socket?
4. Is the aerial cable damaged?
5. Are suitable plugs used to connect the aerial?
6. If you are in doubt, consult your dealer.
No sound
1. Has the TV been set to mute? To cancel mute,
press the "Mute" button, or increase the volume
level.
2. Sound is coming from only one speaker. Is the
balance set to one extreme? See Sound Menu
page 00.
36
For any help concerning set up and use of your TV please call the Customer Helpline: 0845 604 0105
Remote control - does not operate
Your TV no longer responds to the remote control. The
batteries may be exhausted, if so you can still use the
control buttons on the left side of the TV.
Input sources - can not be selected
1. If you cannot select an input source, it is
possible that no device is connected.
2. Check the AV cables and connections if you
have tried to connect a device.
Wrong OSD language
1. Select the language in the setup menu.
2. The language for the sound or subtitles on a
DVD disc cannot be changed.
3. Multilingual sound and/or subtitles are not
recorded on the DVD disc.
4. Try to change the sound or subtitles using
DVD's title menu. Some DVD's do not allow the
user to change these settings without using the
disc's menu.