Mercedes-Benz 2007 CLK 350 Operator's Manual page 406

i
Hex wrench:
You will find the hex wrench for manually operat-
ing the roll bars ( page 413) or the soft top
( page 415) at the lower edge of the storage
well casing.
Removing the vehicle tool kit
Lift up trunk floor cover and engage
trunk floor handle in upper edge of
trunk.
1 Retaining screw
2 Storage well casing
Loosen retaining screw 1 in the mid-
dle of storage well casing 2 by turning
it counterclockwise.
Remove storage well casing 2.
3 Arrow
4 Minispare wheel
5 Vehicle tool kit storage well casing
6 Vehicle tool kit
Remove vehicle tool kit 6.
Practical hints
Where will I find...?
Storing the vehicle tool kit
Place vehicle tool kit 6 in vehicle tool
kit storage well casing 5.
Place storage well casing 2 over the
vehicle tool kit storage well casing 5
and turn retaining screw 1 clockwise
as far it will go to secure the Minispare
wheel.
i
Arrow 3 on vehicle tool kit storage well
casing 5 must point in the direction of travel.
Otherwise you cannot place the storage well
casing 2 on top and secure the Minispare
wheel with retaining screw 1.
Disengage trunk floor handle in upper
edge of trunk and lower trunk floor cov-
er.
!
To prevent damage, always disengage trunk
floor handle from upper edge of trunk and lower
trunk floor before closing the trunk.
405