Hot Water Dispensing Spout; Hot Water-Based Preparations; Hot Water Dispensing; Cleaning And Maintenance - Saeco Incanto HD8917 Instruction Manual

M
E
M
O
M
E
M
O
6.4

Hot water dispensing spout

6.5

Hot water-based preparations

6.5.1

Hot water dispensing

MENU
DRINKS
HOT
WATER
7.

Cleaning and maintenance

12
ENGLISH
Incanto_OTC_EN-IT-DE_Rev01.indb 12
Frothed milk length
Follows the previous instructions in the "6.3.1 Brewing a milk-based product" chapter,
"One frothed milk", until the MILK FROTH function is selected.
>
Keep the OK button pressed a few seconds, and release the button when the machine
displays the necessary sequence of operations: carafe insertion, milk frother dispensing
spout extraction.
Wait for the necessary pre-heating time. The machine is in the programming stage and
is starting to dispense the frothed milk.
>
Press the OK button as soon as the desired quantity has been reached.
Now the button is programmed: every time it is pressed, the machine will brew the
product in the quantity just set. After the product has been brewed, the machine
allows for a quick cleaning of the carafe ducts. Please refer to the "7.4.1 Quick milk
carafe ducts rinse cycle" chapter.
Inserting phase
Tilt the water dispensing spout slightly and insert it completely on the machine tracks.
>
>
Press and rotate the water dispensing spout downwards to lock it to the machine.
Removing phase
Press the two side buttons to unlock the dispensing spout and lift it slightly.
>
>
Pull the water dispensing spout to remove it.
Check that the water dispensing spout is installed. Otherwise, follow the instructions
in the "6.4 Hot water dispensing spout" chapter, "Inserting phase".
Place a container under the hot water dispensing spout.
Burning hazard! At the beginning of each product brewing, hot water or steam sprays
might be present. Wait until the end of the cycle before removing the water dispensing
spout.
>
Press the MENU button.
>
Select the DRINKS function.
>
Select the HOT WATER function. The machine is waiting to start the water dispensing
process.
The water dispensing spout must be installed.
>
Press the OK button to confirm. Wait for the necessary pre-heating time. T he machine
starts dispensing hot water.
Dispense the desired hot water quantity.
>
To stop dispensing, press the OK button. After the product has been brewed, the
machine goes back to the main menu.
Regular cleaning and maintenance of the machine are fundamental to prolong its life
cycle. Otherwise, the machine will stop working correctly. This chapter describes the
details of the operations to be carried out and their schedule.
Make sure to read the "3. Safety" chapter.
All cleaning operations must be carried out when the machine has cooled.
To clean the machine use a wet soft cloth: do not use alcohol, solvents and/or
abrasive objects. Only the drip tray grill and those parts of the carafe indicated in the
"7.4.3 Weekly cleaning of the milk carafe components" section can be washed in the
dishwasher. All other components must be washed in lukewarm water.
Damages or improper use caused by cleaning and maintenance activities are NOT
covered by the warranty.
27/03/15 12:10