Software Upgrades And Region Code Change - Philips DVP3520 Service Manual

Softeware upgrade and region code change
Preparation to upgrade software
1) Power on the set and open the tray, then press "5""5"
on remote control to check the SW File Name.
2) Start the CD Burning software and create a new CD
project (Data Disc) with the following setting:
Label: DVP3XXX (No need the label name)
SW File Name: DVPXXXX_XX.bin
Note: It is required to keep the SW file name accord.
3) Burn the data onto a blank CDR
A. Procedure for software upgrade:
A) Upgrade software via CDR:
1) Power on the set and insert the prepared Upgrade CDR.
2) The set will starts reading disc & response with the
following display TV screen:
Upgrade file detected
Upgrade ?
Press PLAY to start
3) Press "PLAY" button to confirm, then screen will display:
Upgrade file detected
Do not power off
File Copying
4) The upgraded tray will automatically open when file
copying completed, then take out the disc.
5) About 1 minute later, the trace will automatically close
when upgrading completed.
Region Code Change
1) Power on the set and open the tray door;
2) Press the "Setup" button on the remote control, then the
setup interface will be displayed on the TV screen;
3) Move the down cursor on remote control to select "Preferences"
and press "1""3""8""9""3""1" on the remote control;
4) Then move the up or down cursor to select the region code.
Note: Restart after above steps.
Upgrade file detected
Do not power off
Upgrading
4-1
B. Read out the software versions to confirm upgrading
1) Power on the set and press "Setup" button on the
remote control.
2) Press "1""3""7""9" button or press down cursor
on remote control to select "Preferences" and press
right & down cursor to select "Version Info".
The software version and other informations will be
displayed on the TV screen as follows:
Version XX.XX.XX.XX (Main version)
Sub-Ver XX.XX.XX.XX (version of applicaton software)
8032 XX.XX.XX.XX
Servo XX.XX.XX.XX (software version of Servo)
RISC XX.XX.XX.XX
DSP XX.XX.XX.XX
Region Code
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.
X