Advertisement
1. There are 2 ways to software upgrade:
First:
Upgrade from USB:
Copy the upgrade file HTD5510_X X.BIN to USB then press the USB
key on RC or SOURCE key on front panel.
When upgrade file detected, select "Yes" to upgrade, select "Cancel"
to cancel.
After upgrading begins, a message "DO NOT POWER OFF" will show,
or the product will hang up and upgrading failed.
Second:
Upgrade from Disc:
Copy the upgrade file HTD5510_X X.BIN to disc then read the disc.
When upgrade file detected, select "Yes" to upgrade, select "Cancel
"to cancel.
After upgrading begins, a message "DO NOT POWER OFF" will show,
or the product will hang up and upgrading failed.
2. Check the version information after upgraded.
Press the setup key on RC , select Preference Setup, and then
Version info , press OK Key you will see a interface below:
Preference
-----------------------------------------------
File Name
Version
8203RX
RISC
Servo
Region Code
-----------------------------------------------
4-1
Software Upgrade
HTD 5510_ X X.BIN
XX.XX.XXX.XX
19.85.05.16
026.5BXC 03R-A-026
DL0DL2-FAA-774X
2
OK
Advertisement
