Table of Contents
Advertisement
Operation
Engine compartment
Checking engine oil level with the
control system
When checking the oil level the vehicle
must
be parked on level ground
be at normal operating temperature
have been stationary for at least five
minutes with the engine turned off
To check the engine oil level via the
multifunction display, do the following:
Turn the SmartKey in the starter switch
to position 2.
The standard display ( page 109) should
appear in the multifunction display.
Press button k or j on the
steering wheel until the following
message is seen in the multifunction
display:
ENGINE OIL LEVEL
MEASURING NOW
MEASURE. CORRECT
ONLY IF VEH. LEVEL
238
One of the following messages will
subsequently appear in the indicator:
ENGINE OIL LEVEL
OK
ADD 1.0 Qt. TO
REACH MAX. OIL LEVEL!
(Canada:
1.0 LITER
)
ADD 1.5 Qts. TO
REACH MAX. OIL LEVEL!
(Canada:
)
1.5 LITERS
ADD 2.0 Qts. TO
REACH MAX. OIL LEVEL!
(Canada:
)
2.0 LITERS
i
If you want to interrupt the checking
procedure, press the k or j
button on the multifunction steering
wheel.
If necessary, add engine oil.
For adding engine oil, see ( page 239).
For more information on engine oil, see
"Technical data" section ( page 330).
Other display messages
If the SmartKey is not turned to position 2
in the starter switch, the following
message will appear:
FOR ENGINE OIL LEVEL
SWITCH ON IGNITION!
Switch on the ignition.
Advertisement
Table of Contents
