Getting Started; Schlage Utility Software (Sus); Optional Inside Push Button (Ipb); User Management - Schlage AD-300 User Manual

AD-300/AD-301 Networked Hardwired Lock User Guide
Follow these steps to set up a new lock.
1. Install the lock. See the installation guide that came with the lock, or visit
www.schlage.com/support, for more information.
2. Make sure the power is properly connected.
3. Confi gure the Master Construction Credential (where applicable). See Construction Access Mode
on page 5 for more information. The lock should remain in Construction Access Mode until you are
ready to set up the rest of the system.
4. Test the lock for proper mechanical and electronic operation. See Test Lock Operation on page 9
for more information.
5. Connect the lock to the Access Control Panel (ACP). See Connect to an Access Control Panel on
page 7 for more information.
6. Consult the SUS User Guide for information about confi guration of the lock.
7. Familiarize yourself with the information contained in this user guide.
!
Save this user guide for future reference.

SCHLAGE UTILITY SOFTWARE (SUS)

The SUS is used to confi gure locks and the PIB300/PIB301.
!
The SUS is used for programming lock characteristics and setup only. Access rights for the
AD-300/AD-301 are set by the access control panel, not by the SUS.
For more information about the SUS, see AD-Series Locks in the SUS User Guide.

OPTIONAL INSIDE PUSH BUTTON (IPB)

• The IPB state is communicated to the control panel through the RS-485 connection. The manner
in which the network access control software utilizes this communication is confi gured at the
host. The IPB may be used to communicate a lock/unlock request or be completely ignored by
the network software. Activity may only be reported to control systems connected by a RS-485
connection.
• The IPB may be confi gured by the ACP to take direct action on the lock's state in case
communication from the control system to the lock fails and the lock remains powered.
User management is controlled by the access control system. If the access control panel has not yet
been connected, use Construction Access Mode to add and delete users.
See Construction Access Mode on page 5 for more information.

GETTING STARTED

USER MANAGEMENT

4