Sony RCP-920 Operation Manual page 36

b ABSOLUTE (absolute value mode) button
Press and light up this button to set the mode of manual
adjustment with the WHITE, BLACK, FLARE, BLACK
GAMMA, and DETAIL knobs from Relative mode to
Absolute mode.
In the following cases, Relative mode is automatically
selected (the lit button goes dark).
• When an automatic setup (level, white, black) is
completed.
• When a scene file is retrieved.
• When the adjustment mode is switched between the
flare balance and black balance by pressing the FLARE
button.
• When the controlled CCU/HDCU is changed due to the
RCP Assign settings of the master setup unit (MSU).
When the PANEL ACTIVE button is out, or one of the
PARA, MASTER, or SLAVE buttons is lit, Relative mode
is automatically selected and this ABSOLUTE button is
not operative.
c WHITE (white balance manual adjustment) knobs
Used to manually adjust the white balance. From the left,
the knobs are for R, G, and B signal adjustment.
d BLACK/FLARE (black balance/flare balance
manual adjustment) knobs
Used to manually adjust the black balance (when the
FLARE button is out) or the flare balance (when the
FLARE button is lit).
From the left, the knobs are for R, G, and B signal
adjustment.
e Spare button
For future use.
f DETAIL adjustment knob
Turn to adjust the detail level.
g BLACK GAMMA adjustment knob
Turn to adjust the black gamma.
M Camera number/tally indication window
The number of the camera being controlled from this panel
is displayed in orange.
When a red tally signal is sent to the camera, the number
is displayed in black and the background of the number
lights in red.
When a green tally signal is sent to the camera, the number
is displayed in black and the background of the number
lights in green.
When both the red and green tally signals are
simultaneously sent, the left half of the background lights
in red and the right half lights in green.
N NETWORK indicator
Indicates the status during connection to an Ethernet
system.
36
Location and Function of Parts
Lit: Normal connection to the control device (CCU/
HDCU) is established.
Flashing: There is no connection to the control device
(CCU/HDCU).
Out: No camera network connection is established, or
settings for connection to an Ethernet system are not
configured.
O ALARM indicator
Lights in red when trouble occurs in the camera system
and the self-diagnostic function activates at the video
camera head or the CCU/HDCU.
P OPT (optical) indicators
When this panel is used in a camera system with optical
fiber connection, indicates the reception status of the
optical signal (the reception level).
The CAM indicator shows the reception status for the
CCU/HDCU-to-camera link. The CCU indicator shows
the reception status for the camera-to-CCU/HDCU link.
Green: Good reception
Orange: Weakened reception
Red: Severely weakened reception
Out: Connection problem, or no optical fiber connection
Q PANEL ACTIVE button
Press and light up this button to enable control (panel
active condition) of the camera system connected to this
panel. The IRIS/MB ACTIVE button will also be lit at the
same time.
If you press this button so that it goes dark, the panel will
be locked, preventing accidental misoperation.
R CALL button
Press this button so that signal is sent to the camera and the
CALL button on the camera lights. If the tally lamps on the
camera and the red tally lamp on the CCU/HDCU were lit,
they will go dark. Conversely, if they were out, they will
light.
When the CALL button on the camera is pressed, the
CALL button on this panel lights and a buzzer sounds.
S Expanded camera/CCU function ON/OFF buttons
(RCP-921 only)
a KNEE OFF button
Press and light up this button to turn the knee function OFF.
b DETAIL OFF button
Press and light up this button to turn the detail function OFF.
c Spare button
For future use.