Notice - Urive Albatross User Manual

3. Notice

This Section is for your safety and proper use of the Product to prevent safety accidents/risks. The
manufacturer shall not be responsible for troubles caused by use of the Product in violation of the
instructions.
Warning. Ignoring this warning could cause serious injury or even death
If the Product is wet, do not place it in the heater or in
the microwave oven to dry.
It may cause explosion, deformation or product failure which is
not covered under the warranty.
Do not use chemicals (such as benzene, thinner,
alcohol) or detergent to clean the Product.
It may cause fire..
Caution. Ignoring this caution could cause injury or damage to property
If the Product is directly connected to the car, do
not use the product for an extensive period of time.
It may discharge the battery.
Install the Product in unaffected area by the
Navigation or HIPASS device.
Reflections of images of Navigation or HIPASS may cause
poor recording quality.
Make sure that the double-side adhesive tape is
firmly affixed during installation.
The Product may show poor performance by over time
moving or motor vibration.
Keep the windshield clean.
Foreign materials may prevent normal recording of images..
Do not alter or impact on the Product.
Unauthorized alteration or product damage by impact shall not be
covered under the warranty..
Do not install or operate the Product while driving.
Operation of the Product while driving can cause accidents. Pull
over to a safe spot to operate the Product..
Take extra care during installation of the
external camera.
Color of the coating on the rear windshield may impair
the recording quality.
Watch out for using memory cards and removing it.
Uncertified Micro SD card may not be recorded properly.
Please remove the power cable before inserting or
removing the SD Card
Back up files periodically.
When the SD Card is full, the oldest file in the Card will be
overwritten by a new file. Please back up data periodically to
prevent unwanted data loss.
Please do not use sharp devices on the LCD.
The touch panel or LCD may be damaged by sharp devices
when the black box is set up with them on the LCD.
6