User Menus 221-1387; Setup Menu; Clock Menu - Zenith B25A10Z Service Manuallines

SETUP MENU

Shown below is the Setup Menu for CA (A34) chassis
with its options for each item which are described as
follows:
1
AUTO PROGRAM (A34)
The Auto Program feature automatically searches for all
available channels and marks them as 'Added' so that
they may be accessed via the channel Up/Down key.
In the Auto Program screen:
· A message at the top displays "Auto Program" to let
the customer know that he/she has entered the Auto
Program feature.
· A line at the bottom of the screen shows that the
Up/Down and Left/Right Arrow keys are used for Auto
Program selections.
· The current RF input type (Off Air Antenna or Cable
TV) is highlighted. Use the Up/Down Arrow keys to
change the RF input type.
· To start the Auto Program, press the Left/Right Arrow
key. If the Cable TV input type is selected, the Auto
Program routine will determine what type of cable
system is present.
Notes:
•
Auto Program clears all Surfing channels which
were added.
•
While searching for channels, all keys except for
the Power key are disabled. This prevents an
incomplete Auto Program procedure.
•
Running the Auto Program will clear the factory
mode, if it was active. This happens at the end of
the Auto Program.
•
If the Auto Program line in the Setup Menu is
'red', this indicates that the module did not pass
one of the test equipment's tests.
•
If no channels are found then the following
message will appear: "Make sure that the cable/
ant. is connected, and try again."
CM151

USER MENUS 221-1387

CHANNEL Add/Del/Surf
After running the Auto Program, all channels found by
the Auto Program feature will be marked 'Added'. However,
some of these channels may be scrambled, or undesired
by the customer. The Add/Del/Surf feature allows the
customer to selectively mark any channel as 'Deleted' or
'Added'.
To change the status of a channel, press the Right/Left
Arrow key.
To change the channel while adding or deleting
channels, use the Channel Up/Down keys, or press the
desired channel digits, followed by the ENTER key. If
Channel Up/Down is pressed, the next or previous
channel which was marked 'Added' will appear. If only
one channel is present, to change the channel the
customer must use the digit key pad to select a channel.
The following figure shows the options for the Add/
Del/Surf feature.

CLOCK MENU

Clock Set feature contains a Clock Menu for Clock Set
and Date Set
CLOCK SET
When the Clock Set item is selected, pressing the Left/
Right Arrow keys allows entry into the clock set menu.
When no time is set, the display shows:
There are two ways to set the time:
1. Direct Entry (preferred) Use the digit keys, followed
2. Left/Right Arrow keys
When the first digit is introduced, the display shows:
When the time is set, the display shows:
where:
1-29
1
by 'Enter' or Select Up/Down.
—:-d AM < Timer
hh:mm AM < Timer
d = digit, mm = minutes hh = hours
—:— —
CA - 1387 MENUS