User Menus 221-1386; Setup Menu - Zenith B25A10Z Service Manuallines

USER MENUS 221-1386

SETUP MENU

Below is the Setup Menu for the CA Domestic (A30)
chassis with each of its options described below.
Setup Menu
Auto Program
Add/Del/Surf
Clock Set
Captions
Caption/Text
Audio Mode
Language
AUTO PROGRAM
The Auto Program feature automatically searches for all
available channels and marks them as 'added' so that
they may be accessed via the channel Up/Down key.
In the Auto Program screen:
· A message at the top displays "Auto Program" to let
the customer know that they have entered the Auto
Program feature.
· A line at the bottom of the screen shows that the
Up/Down and Left/Right Arrow keys are used for Auto
Program selections.
· The current RF input type (Off Air Antenna or Cable
TV) is highlighted. Use the Up/Down Arrow keys to
change the RF input type.
To start the Auto Program, press the Left/Right Arrow
key. If the Cable TV input type is selected, the Auto
Program routine will determine what type of cable system
is present.
Auto Program
Cable TV
Off Air Antenna
To Change,
Press
CM151
USER MENUS 221-1386
To Program
To Program
1-21
Notes:
•
Auto Program clears all Surfing channels, which
were added.
•
While searching for channels, all keys except for
the Power key are disabled. This prevents an
incomplete Auto Program procedure.
•
Running the Auto Program will clear the factory
mode, if it was active. This happens at the end of
the Auto Program.
•
If the Auto Program line in the Setup Menu is
'red', this indicates that the module did not pass
one of the test equipment's tests.
•
If no channels are found then the following
message will appear: "Make sure that the cable/
ant. is connected, and try again."
CHANNEL ADD/DEL/SURF
After running the Auto Program, all channels found by
the Auto Program feature, will be marked 'Added'.
However, some of these channels may be scrambled, or
undesired by the customer. The Add/Del/Surf feature
allows the customer to selectively mark any channel as
'Deleted' or 'Added'.
To change the status of a channel, press the Right/Left
Arrow key.
To change the channel while adding or deleting
channels, use the Channel Up/Down keys, or press the
desired channel digits, followed by the ENTER key. If
Channel Up/Down is pressed, the next or previous
channel which was marked 'Added' will appear. If only
one channel is present, to change the channel the
customer must use the digit keypad to select a channel.
The following figure shows the options for the Add/
Del/Surf feature.
Setup Menu
Auto Program
Add/Del/Surf
Clock Set
Captions
Caption/Text
Audio Mode
Language
Ch. 5 Added
CA - 1386 MENUS